GRAPHTEC FC5100-100 - SCALE - Enlarging;Reducing an Image Size

Advanced Functions and Settings: SCALE - Enlarging/Reducing an Image Size
81
• Press the F3 key to select FUNCTION 1.
• Press the F3 key to select MIRROR.
• Press the F3 key to turn ON the function or press the F4 key to turn OFF the
function
.
• Press the ENTER key to register your settings.
• Press the MENU key to cancel the menu mode.
When the MIRROR mode is selected or canceled, the displacement of the new
origin remains valid in the “a” direction, but is reset to its default position in the “b”
direction.
SCALE - Enlarging/Reducing an Image Size
This function sets the SCALE factor for enlarging or reducing an image to be cut
or plotted.
• Press the MENU key to select MENU mode.
• Press the NEXT key two times.
INTERFACE>.
AREA PARAMETERS>.
FUNCTION 1>.
FUNCTION 2>.
.
ROTATE>.
MIRROR>.
SCALE>.
MIRROR.
ON*
OFF *
Before MIRROR is selected. After MIRROR is selected.