Setting the Interface Functions: STEP SIZE - Setting the Programmable Resolution
143
• Press the F3 key to select RS-232C; the INTERFACE menu appears:
• Press the NEXT key twice to return to the LOAD MEDIA menu.
How to access
the INTERFACE
menu after load-
ing the media
After the media is loaded and initialization is performed, the plotter goes to
READY mode.
• Press the MENU key to select MENU mode.
• Press the NEXT key two times.
• Press the F1 key to select INTERFACE.
• Press the F3 key to select RS-232C; the INTERFACE menu appears:
• Press the MENU key to return to READY mode.
STEP SIZE - Setting the Programmable Resolution
When HP-GL command mode is selected, STEP SIZE is not displayed. When
the GP-GL command mode is selected, this function allows you to set the distance
of pen movement corresponding to the coordinate value of 1.
STEP SIZE>*
RS-232C>*
COMMAND>*
CONDITION 1........14.
30.
READY.............4.
CB09Ux...0.
INTERFACE>*
AREA PARAMETERS>*
FUNCTION 1>*
FUNCTION 2>*
STEP SIZE>*
RS-232C>*
COMMAND>*
To Next Page
Loading...