Options: FC5100 Stand Manual
160
FC5100 Stand Manual
The FC5100 Stand is used to make the unit more portable, free-up counter
space and make storing your plotter easier. The Stand is optional for the FC5100-
75. It is a standard accessory for the FC5100-100 and FC5100-130 cutters.
WARNING: Use two people to pick up the plotter.
CAUTION: Do not install the plotter onto the stand with the conveyor rollers or media
installed. The unit becomes unstable when heavy loads are added. In
extreme cases, the unit may tip over.
CAUTION: Improper assembly of the stand may cause the unit to become unstable when
heavy loads are added. In extreme cases, the unit may tip over.
CAUTION: The longer length leg platform is installed towards the back of the unit.
CAUTION: To ensure the stability and strength of the stand, all screws should be periodi-
cally inspected and re-tightened as needed.
NOTE: Always keep the wheels in a locked position when operating your plotter.
Contents 1 Base assembly (Qty. 2)
2 Middle Bar (for FC5100-130 and FC5100-130 models, the middle bar is sup-
plied in the cutting plotter shipping box.) (Qty. 1)
3 Stand side (Qty. 2)
4 M5 x 16mm flanged socket head cap screws (Qty. 8)
5 M6 x 16mm socket button head cap screws (Qty. 8)
6 4mm T-handle hex key tool (Qty. 1)
7 4mm L wrench hex key tool (Qty. 1)
8 Cap plugs (Qty. 4)
1
23
4567
8
To Next Page
Loading...