Out of the Box: Checking the Contents
19
Chapter 2: Out of the Box
This chapter describes plotter nomenclature and how to install your plotter.
Checking the Contents
After unpacking your plotter, check that each of the standard accessories shown
below are present. If any accessory is missing, contact your sales representative
or the nearest Graphtec dealer.
Accessories The Stand Kit is an option for the FC5100-75 and is standard for both the
FC5100-100 and FC5100-130 cutters.
Power cord. The configuration pictured
may differ from the actual cord supplied.
Cutter Pen Set. Cutter holder PHP32-
CB09N with two CB09UA cutter
blades.
RS-232 cable with adapter (US mar-
ket only).
Black water-based fiber-tip pen
(KF552-BK-P).
To Next Page
Loading...