GRAPHTEC FC5100-100 - Blade Application and Features

Cutters and Holders: Blade Application and Features
27
Chapter 3: Cutters and Holders
This chapter describes the different cutters and their uses.
Blade Application and Features
Blade part
no. and
type
Diameter
and blade
offset value
Plunger part
no. Applications and features
CB09UA
(supersteel)
0.9 mm
0.45
PHP32-CB09N
or
PHP32-CB09
Standard blade for cutting color adhesive media. Suitable
for cutting media up to 0.25 mm think. Maximum cutting
distance of approximately 4000 m.
CB15U
(supersteel)
1.5 mm
0.75
PHP32-CB15N
or
PHP32-CB15
For cutting media which is too thick for the CB09UA
blade to handle. Suitable for cutting media from 0.25 mm
to 0.5 mm thick.
CB15UA
(supersteel)
1.5 mm
0.75
PHP32-CB15N For cutting high intensity reflective media.
CB15UB
(supersteel)
1.5 mm
0.75
PHP32-CB15N For cutting small characters on mono-vinyl chloride
media. Suitable for cutting small size characters that are
less than 10mm.
CB15U-K30
(supersteel)
1.5 mm
0.75
PHP32-CB15N
or
PHP32-CB15
For cutting sandblast rubber. The sharply angled point
provides a longer cutting edge. Suitable for cutting mate-
rial from 0.05 mm to 1.5 mm thick.
CB15-10C
(ceramic)
1.5 mm
0.50
PHP31-CB15 This is the hardest blade, but may chip or shatter if
dropped or subjected to impact. Suitable for cutting
material up to 0.05 mm thick.
CB15-05S
(sapphire)
1.5 mm
0.25
PHP31-CB15 For cutting masking media. Suitable for cutting material
up to 0.05 mm thick.