Options: FC5100 Media Roll Holder Manual
166
FC5100 Media Roll Holder Manual
The FC5100 Media Roll Holder allows for multiple roll capability and easy stor-
age of your common media colors. The Media Roll Holder is optional for the
FC5100-75, FC5100-100 and FC5100-130 cutter models.
To use the media stored in the Media Roll Holder:
• Always move the roll holders closer together as the rolls become smaller with
use.
• Make sure the diameter of the media is no larger than 6 inches.
WARNING: Use two people to pick up the plotter.
CAUTION: Removing the plotter from the stand when the conveyor rollers are loaded will
cause the unit to become unstable and tip over.
NOTE: Keep casters locked during assembly.
Contents 1 Left Media Roll Holder Bracket (Qty. 1)
2 Right Media Roll Holder Bracket (Qty. 1)
3 Conveyor Rollers (Qty. 2)
4 M6 x 16mm socket button head cap screws (Qty. 4)
5 4mm L wrench hex key tool (Qty. 1)
Media Roll
Holder Assembly
The following information will give you step-by-step instructions on how to
assemble the Media Roll Holder Assembly for the GRAPHTEC FC5100 Cutting
Plotter. For the best results follow all instructions carefully.
A
SSEMBLY AREA
Assemble the Media Roll Holder on a secure, flat surface. You will be using the
4mm L wrench hex key tool provided with your Media Roll Holder assembly.
To Next Page
Loading...