Options: FC5100 Auto Registration Mark Sensor
177
• Press the F1 key to select AUTO REG. MARK.
• Press the F1 key to select MARK SCAN MODE.
• Press the F3 key to select 2-POINTS Method or press the F4 key to select 3-
POINTS Method.
• Press the F2 key to select DISABLE when you do not wish to use the AUTO
REG. MARK sensing function. A mark appears next to the current setting.
• Press the ENTER key to register your setting. If you selected the 2-POINTS
method or the 3-POINTS method, the next setting menu appears. Continue to
set other parameters or press the NEXT key to return to the previous menu.
• Press the NEXT key until the “LOAD MEDIA!” message appears to cancel the
menu mode. Raise the media set lever, and then continue the initial mode.
Setting the Reg-
istration Mark
Reading Area
The AUTO REG. MARK sensing function senses the registration mark by moving
the media or the sensor until the plotter locates the registration mark. Normally
there is nothing printed in between the registration marks in order to prevent any
sensing errors, however an image can be printed between the registration marks if
you tell the plotter where to read the registration marks.
You can specify areas that the plotter will not sense by simply specifying the dis-
tance between the registration marks. Once the plotter locates the first registration
mark, it will automatically move the specified distance and begin scanning for the
next mark. You can also use this function to reduce mark-sensing time. Before you
AUTO REG. MARK>*
AUTO PRE FEED>*
INITIAL FEED SPEED>*
INTERFACE>*
MARK SCAN MODE>*
MARK TYPE>*
OTHER SETUPS>*
MARK SCAN MODE *
DISABLED *
2POINTS *
3POINTS*
MARK SCAN MODE *
DISABLED*
2POINTS *
3POINTS *
To Next Page
Loading...