Options: FC5100 Auto Registration Mark Sensor
178
begin, you must know the distance between registration marks. The plotter can
save up to three sets of settings.
• Press the MENU key to select MENU mode.
• Press the NEXT key.
• Press the F1 key to select AUTO REG. MARK.
• Press the F1 key to select MARK SCAN MODE.
• Press the F3 key to select the 2-POINTS Method or press the F4 key to select
the 3-POINTS Method. A mark appears next to the current setting.
•
Press the ENTER key to register your setting. If the current setting is at
2-POINTS or 3-POINTS, press the NEXT key to advance to the next
menu.
• Press the F1, F2 or F3 key to select the number you wish to store the settings
under. A mark appears next to the current setting.
• Press the F3 key or the F4 key to select the axis for setting the distance.
• Press the LEFT or RIGHT ARROW key to move the blinking cursor for selecting
the digit, and then press the UP or DOWN ARROW key to change the number.
AUTO REG. MARK>*
PEN UP/DOWN>*
BUFFER CLEAR>*
FEED>*
MARK SCAN MODE>*
MARK TYPE>*
OTHER SETUPS>*
SENSOR OFFSET ADJ>*
MARK SCAN MODE *
DISABLED *
2POINTS*
3POINTS *
SCAN MARK ........ ..1>.
2>.
3>.
MARK POSITION
X = ...0000
mm*.
Y = ...0000 mm*.
To Next Page
Loading...