Test Modes and Troubleshooting: SELF TEST - Running the Self Test
129
• Press the F4 key to select OPTION 2.
• Press the F4 key to select TEST.
• Press the F3 key to select SELF TEST.
The following message appears:
Confirm that the pen is mounted on the carriage .
• Press the F3 key to start plotting or press the F4 key to cancel plotting.
You may have to turn off the plotter to cancel SELF TEST if the plotter is in the
SELF TEST mode.
The following message appears:
When you have finished printing the SELF TEST pattern, turn off the plotter to
cancel SELF TEST mode.
NOTE: The self-test pattern is repeadtedy printed until the plotter is turned off. To stop
printing, even if a pattern is not completely printed, simply turn off the plotter
BACKGROUND SETTINGS>*
OPTION 1>*
OPTION 2>*
INITIAL DOWN FORCE>*
DISTANCE ADJUST>*
TEST>*
CONDITON LIST>*
SELF TEST>*
DATA DUMP>*
MOUNT THE PEN!
........DONEDONE>.
CANCEL SELF TEST>.
SELF TEST
To Next Page
Loading...