GRAPHTEC FC5100-100 - AXIS ALIGNMENT - Axis Alignment Parameter Setting

Advanced Functions and Settings: DATA SORTING - Sorting the Cut Data
83
• Press the F4 key to select FUNCTION 2.
• Press the F1 key to select DATA SORTING.
• Press the F3 key to turn AREA sorting ON or OFF. Press the F4 key to turn PEN
sorting ON or OFF
.
• Press the ENTER key to store your setting. If the sorting OFF is selected, return
to the previous menu.
If sorting ON is selected, the following menu will appear.
• Press the F3 key to select CONTINUE or press the F4 key to select CANCEL for
the data sorting mode setting.
If CONTINUE is selected, the MEDIA TYPE MENU then appears. Select the
media type you wish to use.
INTERFACE>.
AREA PARAMETERS>.
FUNCTION 1>.
FUNCTION 2>.
DATA SORTING>.
AXIS ALIGNMENT>.
AUTO PRE FEED>.
TANGENT EMULATION>.
DATA SORTING
.
AREA ON*
PEN OFF *
DATA SORTING>.
AXIS ALIGNMENT>.
AUTO PRE FEED>.
TANGENT EMULATION>.
THIS OPERATION
RESETS THE PLOTTER!.
CONTINUE>.
CANCEL>.
ROLL-1>.
ROLL-2>.
SHEET>.
CONTINUE>.