Test Modes and Troubleshooting: CONDITION LIST - Listing the Cutting Conditions
126
The following message appears:
Confirm that the pen is mounted on the carriage.
• Press the F3 key to select DONE and start plotting or press the F4 key to select
CANCEL CONDITIONS.
You have to turn off the plotter to cancel CONDITION if the plotter is in CONDI-
TION mode. The following message appears and the plotter begins printing a list
of the currently set cutting conditions.
When all of the data has been printed, turn off the plotter to cancel CONDITION
mode.
Sample printout
of the CONDI-
TION function
FC5100 CONDITIONS
MOUNT THE PEN!
........DONEDONE>.
CANCEL CONDITIONS>.
PRINT CONDITIONS
COND FORCE SPEED PEN TYPE OFST ACCL TANGNT OVCUT DIST. ADJ.
11430CB09Ux 04 OFF OFF
2 14 60 PEN 0 4 OFF OFF
32030CB09Ux 04 OFF OFF
43015CB15Ux 04 OFF OFF
53815CB15Ux 04 OFF OFF
6 38 10 CB15U-K30x 0 2 OFF OFF
7 17 30 OTHER +17 4 OFF OFF
8 12 30 POUNCE + 1 4 OFF OFF
RS232C BAUD RATE PARITY DATA BIT HANDSHAKE
*1 9600 N 8 H
2 9600 E 7 H
3 9600 E 8 H
COMMAND GP-GL STEP SIZE 0.100 : ; : COMMAND ENABLED MODEL EMULATED 7550
HP-GL ORIGIN L.L. PAGE LENGTH 2000 W COMMAND PEN DOWN PEN UP MOVE ENABLED
PEN UP SPEED AUTO STEP PASS 0 COND. PRIORITY MANUAL MEDIA SIZE SENSOR OFF
OFFSET FORCE 4 OFFSET ANGLE 30 INIT. BLADE CTRL 2mm BELOW PINCH ROLLER OFF
ROTATE OFF MIRROR OFF DISPLAY LANG English HL CIR RESOL DEFAULT
INIT. DOWN F. 0
DISPLAY UNIT mm COPY SPACE 1
AXIS METHOD 2 POINT
AUTO PRE FEED DISABLED PRE-FEED LENG 1
TANGENTIAL MODE MODE 1 FEED SPEED NORMAL
EXPAND LENG 0 SORT DISABLED ROM Version 1.20
To Next Page
Loading...