GRAPHTEC FC5100-130 - MIRROR - Reversing the Image

Advanced Functions and Settings: MIRROR – Reversing the Image
80
• Press the F2 key to select ROTATE.
• Press the F3 key to turn ON the function or press the F4 key to turn OFF the
function.
• Press the ENTER key to register your settings or press the MENU key to cancel
MENU mode.
When the ROTATE mode is selected or canceled, the displacement of the new
origin remains valid in the “a” direction, but is reset to its default position in the “b”
direction.
MIRROR – Reversing the Image
To cut a reversed image of the original data, use the mirror mode. When the
mirror mode is enabled, the origin and coordinate axes are changed as shown in
the figure below. A mirror image of the original data is cut.
• Press the MENU key to select MENU mode.
• Press the NEXT key two times.
ROTATE>.
MIRROR>.
SCALE>.
ROTATE
.
ON*
OFF *