Options: FC5100 Basket Manual
163
FC5100 Basket Manual
The FC5100 Basket is used to keep your media clean during long length cuts.
WARNING: Use two people to pick up the plotter.
CAUTION: Remove the plotter from the stand before assembling the basket onto the
stand.
NOTE: The basket was designed to be used with Graphtec recommended media only.
Other media may be stiffer and will not flow into the basket smoothly.
NOTE: Always keep the wheels in a locked position when operating your plotter.
Contents 1 M6 x 12mm socket flange head cap screws (Qty. 4)
2 Cloth basket (Qty. 1)
3 Basket holder assembly (which consists of a front basket tube and a rear
basket tube assembled on the tube bracket.) (Qty. 1)
4 Middle basket tube (Qty. 1)
5 4mm L wrench hex key tool (Qty. 1)
Basket Assembly The following information will give you step-by-step instructions on how to
assemble the Basket Assembly for the GRAPHTEC FC5100 Cutting Plotter. For
best results, follow all instructions carefully.
ASSEMBLY AREA
Assemble the Basket on a secure, flat surface. You will be using the 4mm L
wrench hex key tool provided with your Basket assembly.
1 Lock the casters. The front and rear basket tubes have been assembled into
the tube brackets. Attach one (1) of the tube brackets to the upper two (2)
holes in the left side of the stand with two (2) M6 x 12mm socket flange head
To Next Page
Loading...