GRAPHTEC FC5100-130 - ORIGIN - Setting the Origin in HP-GL Mode

Advanced Functions and Settings: ORIGIN - Setting the Origin in HP-GL Mode
72
• Press the F4 key to select FEED.
• Press the UP and DOWN ARROW keys to obtain the desired FEED LENGTH.
• Press the ENTER key to register your settings. The plotter will start feeding as
soon as the ENTER key is pressed.
• Press the MENU key to cancel MENU mode.
ORIGIN - Setting the Origin in HP-GL Mode
There are two types of origins: Center and Lower Left. If HP-GL™ utilizes the
Center mode and the plotter utilizes the Lower Left Origin point, you may lose plot
data that is located in the upper right quadrant. The ORIGIN mode allows you to
alternate between both origin types in HP-GL™ mode.
• Press the MENU key to select MENU mode.
• Press the NEXT key two times.
• Press the F2 key to select AREA PARAMETERS.
.
PEN UP/DOWN>.
BUFFER CLEAR>.
FEED>.
FEED LENGTH
1 m
Center Origin Lower Left Origin Designed with
Center Origin and
plotted with a
Lower Left Origin
INTERFACE>.
AREA PARAMETERS>.
FUNCTION 1>.
FUNCTION 2>.