Background Settings: Background Settings for HP-GL
122
Circle Resolution Use this selection to achieve smoother cut/plot quality on large circles or arcs
when drawing with the circle or arc commands.
When AUTO is selected, the resolution of circles and arcs will be automatically
optimized.
When DEFAULT is selected, the resolution of circles and arcs is always 5
degrees. If the circle or arc consists of short line segments, the quality of the cir-
cle or arc will not change by this setting.
• Press the F3 key to select AUTO or press the F4 key to select DEFAULT. A
blinking cursor appears beside your choice.
• Press the ENTER key to register your setting and to proceed to the next menu.
Press the NEXT key if you wish to bypass this setting with no changes.
If you used METHOD 1 to select BACKGROUND SETTINGS, press the MENU
key if you do not wish to make any changes. If you used METHOD 2 to select
BACKGROUND SETTINGS, turn off the plotter if you do not wish to make any
changes.
Check Pen This setting is availabe when the 2 Pen option is installed. The 2 Pen option
installed machine can hold one blade or pen in the pen holder on the pen carriage
(which is referred to as PEN 1) and one pen in the pen holder on the right side
plate (which is referred to as PEN 2). This function is used to enable or disable
checking PEN 2.
When ENABLE is selected, the plotter checks to see if PEN 2 is installed. This
check if performed during the plotter’s initialization after selecting the media type.
When DISABLE is selected, the plotter does not check to see if PEN 2 is
installed uring the plotter’s initialization after selecting the media type.
CAUTION: If DISABLE is selected, the PEN 2 should be installed before turning on the
plotter.
CIRCLE RESOLUTION
AUTO.
DEFAULT_.
CHECK PEN
ENABLED.
DISABLED_.
To Next Page
Loading...