Background Settings: Background Settings for GP-GL
109
Background Settings for GP-GL
LANGUAGE
SELECTION
You may select one of the following 12 languages for the operation menu: Dan-
ish, Dutch, English, French, German, Hungarian, Italian, Japanese, Norwegian,
Portuguese, Spanish and Swedish.
• Press the UP and DOWN ARROW keys to select the desired language.
• Press the ENTER key to register your setting and to proceed to the next menu.
The next setting menu appears in the select language. If you used METHOD 1
to select BACKGROUND SETTINGS, press the MENU key if you do not wish to
make any changes. If you used METHOD 2 to select BACKGROUND SET-
TINGS, turn off the plotter if you do not wish to make any changes.
• Press the NEXT key if you wish to bypass this setting with no changes.
“:” “;” Command
Control (“:” “;”
COMMAND)
When the GP-GL command mode is selected, set this function to enable or dis-
able the recognition of “:” and “;” commands set from the computer.
These commands may adversely affect the cutting results if the leading section
of data is missing. In such cases, set this function to DISABLED.
• Press the F3 key to select ENABLED or press the F4 key to select DISABLED. A
blinking cursor appears beside your choice.
Press the ENTER key to register your setting and to proceed to the next menu.
Press the NEXT key if you wish to bypass this setting with no changes. If you used
METHOD 1 to select BACKGROUND SETTINGS, press the MENU key if you do
LANGUAGE SELECTION
[ ENGLISH ]
COMMAND ; AND :
ENABLED.
DISABLED_.
COMMAND ; AND :
ENABLED.
DISABLED_.
To Next Page
Loading...