GRAPHTEC FC5100-130 - ROTATE - Rotating the Coordinate Axes

Advanced Functions and Settings: ROTATE - Rotating the Coordinate Axes
79
• Press the F2 key to select AREA PARAMETERS.
• Press the F4 key to select PAGE LENGTH. (ORIGIN in the 1
st
row appears in
HP-GL™ mode only.)
• The following page length menu appears:
• Press the LEFT or RIGHT ARROW key next to the blinking cursor to the next
digit to the left or right.
• Press the UP or DOWN ARROW key to increase or decrease the L value.
• Press the ENTER key to register your settings or press the MENU key to cancel
MENU mode.
NOTE: Your PAGE LENGTH setting is retained in the plotter’s internal memory even
while the plotter is turned off. By specifying a long PAGE LENGTH, your plotter
can perform long-axis plotting to produce banners of up to 50m in length.
ROTATE - Rotating the Coordinate Axes
This function is used to move the origin and rotate the coordinate axes by 90° as
shown in the figure below.
• Press the MENU key to select MENU mode.
• Press the NEXT key two times.
• Press the F3 key to select FUNCTION 1.
INTERFACE>.
AREA PARAMETERS>.
FUNCTION 1>.
FUNCTION 2>.
ORIGIN>.
AREA>.
EXPAND>.
PAGE LENGTH>.
PAGE LENGTH.
L = 02000 mm.
INTERFACE>.
AREA PARAMETERS>.
FUNCTION 1>.
FUNCTION 2>.