Advanced Functions and Settings: COPY - Copying the Data in Plotter Buffer Memory
68
If the receive buffer is empty the following message will appear. You will need to
re-send the data to the plotter by returning to the previous menu.
If one block of the data sent from the computer has exceeded the plotter’s
receive buffer size (2Mbyte), the following message will appear. Return to the pre-
vious menu. You will need to divide the data into smaller sizes or segments so that
it fits the plotter’s receive buffer. After doing so re-send the data.
Use the UP or DOWN ARROW key to increase or decrease the copy space after
the COPY SPACE menu appears.
• Press the ENTER key to store the setting. If the effective cutting area is smaller
than the area required to cut one copy, the following menu appears:
• Press the F4 key to return to the start menu. If the effective cutting area is avail-
able, the following menu appears:
CAUTION:The number of copies is limited by the PAGE LENGTH setting.
• Press the UP and DOWN ARROW keys to increase or decrease the number of
copies. The number can be increased up to the maximum number of copies that
can be cut out of the currently loaded media. You may re-load additional media
to achieve the number of copies you wish to cut. Then reset the copy function
again.
NO DATA FOR COPY
IN BUFFER !
BUFFER IS FULL
CANNOT COPY!
COPY SPACE
5 mm
CANNOT COPY
CUT AREA TOO SMALL
OK>.
COPY MODE
NUMBER OF COPIES
[ 1 ]
To Next Page
Loading...