Options: FC5100 Auto Registration Mark Sensor
186
• Press the F3 key to select OTHER SETUPS.
• Press the F4 key to select PAPER-WEIGHT
• Press the F3 key to enable this function. Press the F4 key to disable this func-
tion. A mark appears next to the current setting.
Note: When ON is selected, the plotter will move to the home position to enable the
PAPER-WEIGHT mechanism before and after the plotter scans the registration
mark.
• Press the ENTER key to register your setting. The following menu appears. If
you wish to set another parameter, press the key corresponding to that setting.
•
Press the MENU key to cancel menu mode when all of the parameters
are set.
Setting the SEN-
SOR OFFSET
ADJustment
The SENSOR OFFSET ADJ function is used to determine the corrective values
you should input in order to adjust the precision of the registration mark sensor.
The plotter utilizes an optical sensor to sense or read a registration mark that is
not in the same location as the pen. There are two methods available to adjust the
offset factor:
METHOD 1: The plotter scans a printed cross mark then plots a second
cross mark based on the reading of the printed cross mark.
The plotter then adjusts for offset.
METHOD 2: The plotter plots the cross mark, reads it, then plots another
cross symbol for use in determining the corrective values to
be input in order to adjust the precision of the registration
MARK SCAN MODE>*
MARK TYPE>*
OTHER SETUPS>*
SENSOR OFFSET ADJ>*
MARK SIZE>*
DISTANCE ADJUST>*
AXIS ORIGIN OFFSET>*
PAPER-WEIGHT>*
PAPER-WEIGHT
ON*
OFF *
MARK SIZE>*
DISTANCE ADJUST>*
AXIS ORIGIN OFFSET>*
PAPER-WEIGHT>*
To Next Page
Loading...