Options: FC5100 Auto Registration Mark Sensor
187
mark sensor. The plotter plots the second cross mark based
on the reading of the first cross mark then adjusts for offset.
Note: To avoid confusion, plot using different color pens between the first and second
cross marks.
• Load the media and set the pen in the plotter.
If you wish to use METHOD 1,
you must load media with a printed cross mark.
• Press the MENU key to select MENU mode
• Press the NEXT key
• Press the F1 key to select AUTO REG. MARK
• Press the F4 key to select SENSOR OFFSET ADJ
•
Press the F3 or F4 key to select METHOD 1 or METHOD 2
Select either METHOD 1 or METHOD 2
SELECTING METHOD 1
The plotter scans a printed cross mark and then plots a second cross mark
based on the reading of the printed cross mark. The plotter then adjusts for offset.
• Press the POSITION key to move the pen near to the pre-printed cross mark.
AUTO REG. MARK>*
PEN UP/DOWN>*
BUFFER CLEAR>*
FEED>*
MARK SCAN MODE>*
MARK TYPE>*
OTHER SETUPS>*
SENSOR OFFSET ADJ>*
SENSOR OFFSET ADJUST
METHOD 1>.
METHOD 2>.
To Next Page
Loading...