GRAPHTEC FC5100-130 - Page 189

Options: FC5100 Auto Registration Mark Sensor
188
• Press the F4 key to select SCAN
The plotter scans the pre-printed cross mark, then plots the cross mark.
You must measure the distance between the pre-printed cross mark and the
cross mark plotted by your plotter. If the location of the two cross marks match,
press the NEXT key to cancel this mode. If the location of the cross marks do not
match, change the PARAMETER SET.
• Press the F3 key to select PARAMETER SET. The following menu appears:
Press the F3 or F4 key to select the axis for setting distance. Press the F2 key
to toggle polarity for the distance setting, the “–“ mark appears on the distance
setting when negative is selected.
Press the LEFT or RIGHT ARROW key to move the blinking cursor to select the
digit, then press the UP or DOWN ARROW key to change the number.
SENSOR OFFSET ADJUST
PARAMETER SET>.
SCAN>.
SENSOR OFFSET ADJUST
PARAMETER SET>.
SCAN>.
SENSOR OFFSET ADJUST
+/- >.
X = ...00.0 mm*.
Y = ...00.0 mm*.
Printed target mark
Media feed
direction
Move the pen into this area.
Media feed
direction
Printed target mark
Axis direction
+Y
X
Y
Cross mark is plotted
by the plotter
-X
-Y
+X