GRAPHTEC GL240 - Setup of Printer; Setup of Measuring Instrument

E-3
SetupofPrinter
• Attachthebatteryontherearside.
• ConnecttheACadaptertothepowerportoftheprinter.
• Pressthepowerbuttonoftheprintertoturnontheprinter.
Thebatteryischargedwhentheprinteristurnedon.
Thebatteryisnotchargedwhentheprinteristurnedoff.
Whenthealertlampgoesoff,printingisavailable.
(Fordetails,seetheUser'sManualforDP-581H.)
• Openthepapercoverandloadtherecordingpaperwithoutslackness.Pullouttherecording
paperbyapproximately5cm.
Payattentiontotherecordingpaperloadingorientation.
(Fordetails,seetheQuickStartGuideforDP-581H.)
• Closethepapercover,andpressthepaperfeedbuttontwiceconsecutivelytoperform
self-testprinting.Ifthetestprintingiscompleted,theprinteroperatesnormally.
Donotattachorremovethebatterywhileprintingisperformed.
Doingsomaycauseabreakdownormalfunctionoftheprinter.
Besuretoturnofftheprinterbeforeattachingorremovingthebattery.
Thebatteryoftheprinterisintendedforuseinaplacewherepowersourceisnotavailable.Itis
notintendedtobeusedasabackupforACpowersourceloss.
SetupofMeasuringInstrument
■Checkingfirmware
Thefollowingdevicescanbeconnectedwiththeprinter.Ifyoualreadyuseadevice,firmware
updateforthedeviceisrequired.
Thefirmwarecanbedownloadedatourwebsite.
Downloadpage:
http://www.graphteccorp.com/support/software/instruments.html
Supportedmodels Operablefirmwareversion Connectionmethod
GL240 Ver.1.50 WirelessLANconnection
GL840 Ver.1.50 WirelessLANconnection,WiredLAN
connection(*1)
GL980 Ver.1.30 USBconnection(*2),WiredLANconnection
(*1)
GL2000 Ver.1.30 USBconnection(*2),WiredLANconnection
(*1)
*1 ToconnectviawiredLAN,prepareacommerciallyavailablewirelessLANrouterandLANcable.
*2 USBhubisnotsupported.Ifitisused,operationmaynotbecorrectlyperformed.