GRAPHTEC GL820 - Page 11

2. Setup: How to Make the Settings
Make the settings required for data capture. Here we will make only those settings that are
minimum requirement. The other settings will be not changed from the factory default settings.
Basic Setup Menu Operation
The Wa key, the ENTER key, and the QUIT key are used to set the condition on the setup menu.
The current position of the cursor on the setup menu is displayed in green. Use the Waed>keys
‘to move the cursor. If you press the ENTER key at the cursor position, a selection menu or a box
of entering value for selected item is displayed. If you press the QUIT key, the screen clases
and the settings are canceled.
- Examples of selection menu operations (AMP screen;
1. Use theva keys to move the 3. Press the ENTER key to confirm your
cursor to the Input parameter of econ.
(GH 1 and then press the ENTER key.
(Note: Select "DC" for voltage measurement, and "Humidity" for humidity measurement.)
1. Press the MENU key to display the setup menu screen.
Fag 2- Set Input to “TEMP” and Range to "TC-T" for CH1,
and set Input to "DC" and Range to “1V" for CH2.
(1) Move the cursor to CH1 "Input" and select "TEMP" and then move it
to "Range" and select "TC-T."
=—
(2)
In
the
Same
Way,
move
the
cursor
to
CH2
“Input”
and
select
then move it to "Range" and select "1V."
3. Select "Off" for all the other channels.
(1) Using the procedure described above, select "Off" for CH 3 to CH 10.
Bi» Use the CH GROUP key to switch to the CH11 to CH20 group.
review