GRAPHTEC GL840 - Introduction; Notes on Use; Notes on Radio Law

E-8
■Howtodisplayprinterwebscreen
1.
Turnontheprinter.
2.
ConnecttheprinterandthecomputerusingtheaccompaniedUSBcable.
3.
Waituntiltheprinterstartupiscomplete,andthepowerlamp(green)lightsup
andtheerrorlamp(red)goesoffonthecontrolpanel.
4.
Pressthepowerbuttononthecontrolpaneltwiceconsecutively.
5.
Theprinterisinthesettingmode,andthepowerlamp(green)andtheerrorlamp
(red)flashsimultaneously.
6.
Afterwaitingforapproximately30seconds,openawebbrowser(suchasInternet
Explorer)andenter169.254.200.1intheaddressbar.Theloginscreenshown
belowisdisplayed.
*Iftheloginscreenisnotdisplayedafterenteringtheaddress,tryagainafterawhile.Atthefirst
connectionordependingoncomputers,itmaytakeafewminutesfortheprinterthatisswitched
toWebsettingmodetoberecognized.
7.
Enter0000forthepasswordandpressthe[Enter]key.TheWebscreenas
shownbelowwillbedisplayed.
8.
Whenthescreenasshownaboveisdisplayed,specifyingsettingsonthewebis
available.
Toconnectwiththemeasuringinstrument,select[WIFIConfig]shownabove.
Forotherdetailedsettings,seetheUser'sManualoftheprinter.
9.
Next,specifytheWi-Fisettingsontheprinter.