4. Press the [MENU] key and open the "DATA" menu.
Press the [MENU] key. Next, move the cursor to the “DATA” in the "MENU"
at the top.
5. Set the sampling interval to "1s".
Move the cursor to "Sampling" and then select "1s".
6. Set the Data Capture Destination to "SD memory card".
Here the "TEST" folder is created in the <SD1> , and then destination for the
captured data is set to the TEST folder.
(1) Move the cursor to the File Name parameter and then press the [ENTER]
key.
(2) Move the cursor to the <SD1> item in the following screen, press the
[ENTER] key.
(3) The file settings box shown in the following screen opens.
In the file box, set the file name to record in the SD memory card.
* The remaining memory capacity is
indicated in the <SD1> when the SD
memory card is mounted.
When the SD memory card is not
mounted, 0 Bytes is indicated.
13
To Next Page
Loading...
