GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Id.-Nr. 0058674 03/2008
28
Switch the motor on, and give the aeroplane a firm hand-launch directly into
any breeze; trotting forward for a few paces gives the correct launch speed.
Keep the model flying straight ahead with minimal rudder commands. If the model
tends to turn by itself, adjust the trim sliders below and adjacent to the transmitter
sticks. Move the sticks gently and smoothly initially, and keep the model flying
straight or in broad turns.
Important: initial brief application of rudder initiates a turn (the model banks);
the rudder stick should then be centred again. Holding the rudder “on” for a
long period will eventually cause the aircraft to fall into a spiral dive. Always
land the machine on the glide (motor stopped), heading exactly into wind. Reduce
the model’s airspeed just before touch-down by progressively applying up-elevator.
Always land straight into any wind.
All of us at Graupner Modellbau hope you have many fine flights with your new >
TERRY S <.
Parts List - TERRY S
Part
No.
Description No. off Material
1 Fuselage 1 SOLIDPOR Ready made
2 Fuselage reinforcement 1 Spruce 450 x 6 x 6
3 Captive nut 1 Steel Ready made, M4
4 Fin 1 SOLIDPOR Ready made
5 Rudder snake outer sleeve 1 Nylon 1.9 Ø / 0.9 Ø x 380
6 Elevator snake outer sleeve 1 Nylon 1.9 Ø / 0.9 Ø x 440
7 Rudder pushrod 1 Steel 0.8 Ø x 435
8 Elevator pushrod 1 Steel 0.8 Ø x 515
9 Control surface horn 2 ABS Ready made
10 Tailplane 1 SOLIDPOR Ready made
11 Sleeve 1 Aluminium Ready made
12 Countersunk screw 2 Nylon M4 x 16
13 Insert 2 Nylon M4 x 10
14 Countersunk screw 2 Nylon M4 x 30
15 Wing 1 SOLIDPOR Ready made
16 Screw sleeve 2 Aluminium Ready made
17 Carbon fibre tube 1 CFRP 6 Ø / 4 Ø x 390
18 Canopy 1 ABS Ready made
19 Self-tapping screw 1 Steel 2.9 Ø x 16
20 Velcro tape, fine 1 Nylon 12 x 12 x 2
21 Velcro tape, coarse 1 Nylon 25 x 15 x 2
22 Velcro tape, fine 1 Nylon 40 x 25 x 2
23 Velcro tape, coarse 1 Nylon 40 x 25 x 2
24 Servo output arm 2 Nylon Ready made
25 Decal 10 Adhesive film Sheet
To Next Page
Loading...
