Page 51/53
14. ERROR MESSAGE SCREEN
The error will be displayed on the LCDisplay.
[ INPUT VOLTAGE ]
[ NO BATTERY ]
[ REVERSE POLARITY ]
* The present input * A battery is not * A battery is
voltage is _0.00V. connected to the connected to the
* Please check the output output in reverse !
input voltage. * Please connect the * Please correctly
* The input voltage battery to the connect the battery
must be 11-15V. to the output.
output then
restart !
[ OPEN CIRCUIT ]
[ SHORT-CIRCUITED ]
[LOW OUTPUT VOLTAGE ]
* A battery is * Output short- * Output voltage is
disconnected during circuited. lower than the
an operation. * Please check the selected cells or
output.
* Please reconnect voltages
the battery and * Please select
restart!
proper cells or
voltages
[HIGH OUTPUT VOLTAGE]
[TEMPERATURE SENSOR ]
[ BAT. TEMP TOO LOW ]
* Output voltage is * A temperature * Battery temp is too
higher than the sensor is connected low to be operated!
selected cells or in reverse or is
defective.
voltages
* Please select
proper cells or OUTPUT _0.000V
voltages BATT TEMP __0.0°F
[ BAT. TEMP TOO HIGH]
[ INTERNAL TEMP ]
[DATA COMMUNICATION ]
* Battery temp is too * Internal temp is * Something is wrong
high to be operated! too hot ! with the internal
* Contact Hobby circuit.
Services if this * Contact Hobby
message appears Services
often.
OUTPUT _0.000V
BATT TEMP __0.0°F
[ BAL.VOLTAGE HIGH ]
[ BAL.VOLTAGE LOW ]
[ CALIRATION DATA ]
* Balancer cells * Balancer cells *Either calibration
voltage is too voltage is too data or internal
high !! low !! circuit might have
over cell is [0] low cell is [0] been damaged.
[ NO SENSOR ]
[MOTOR OVER CURRENT ] [ LINK COMMAND ]
* Link order failed ! * A temp-sensor is * Please reconnect
Error occured in the not connected to the the motor and
counterpart channel ! restart!
port
* Please connect the
temp-sensor to the
port then restart !
[ CONNECTION ]
[ MOTOR FUNCTION ]
* selected cells and * Can not start the
cells connected to motor function,
the balancing port because other Output
are different ! is used !
* Please recheck and * Please stop other
restart !
Output function to
start the motor !
To Next Page
Loading...
