GB - 11
• To turn to the right; pull the right hand lever up.
• To move in reverse:
1. Place steering levers in neutral.
2. Engage steering lever latches.
3. Engage the operator presence control and move
shift lever to Reverse.
4. Hold steering levers in neutral and release
latches.
5. Release steering levers slowly.
To mow:
1. Place steering levers in neutral.
1. Engage steering lever latches.
1. Move the shift lever to the neutral position.
2. Slow the engine down to about half speed.
3. Engage operator presence control lever.
4. Move the PTO switch to On to engage mower.
5. Move the throttle lever to the Fast position.
IMPORTANT: NEVER engage the PTO if the mower is
plugged with grass or other material. This will damage
the PTO belt.
6. Move the shift lever to set a slow ground speed.
7. Hold steering levers in neutral and release
latches.
8. Release steering levers slowly.
When you know how to operate the unit, select a speed
appropriate to your mowing conditions.
To disengage mower, move the PTO switch to Off.
To stop:
1. Pull both steering levers to neutral position.
2. Lock the steering lever latches in neutral.
3. Keep one hand on the operator presence control
and move the shift lever to the neutral position.
4. Move the throttle lever to Slow.
5. Turn the ignition key to Off.
PARKING
1. Stop unit and shut off engine.
2. Remove the key.
3. Pull both levers all the way up and engage both
steering latches. The brake is applied when the
steering levers are in neutral.
4. Chock or block the wheels if parked on a slope.
TO PUSH UNIT BY HAND
To move the unit without the engine running:
1. Turn the engine off.
2. Move shift lever to neutral.
3. Hold steering levers in neutral and disengage
latches. Release steering levers. The brake is
disengaged when the steering levers are
released.
IMPORTANT: Never tow unit.
TO TRANSPORT UNIT
ALWAYS shut off engine, remove key and drain fuel
when transporting unit on a truck or trailer. Use extra
care when loading or unloading unit onto trailer or
truck.
Secure unit chassis to transport vehicle. NEVER
secure from rods or linkages that could be damaged.
DO NOT transport machine while engine is running.
WARNING: Uncontrolled reverse travel can
result in serious injury.
Do not put shift lever into the reverse position
unless you are prepared to operate in
reverse.
OG1210
To Next Page
Loading...
