Gravely Promaster 266 - Page 21

GB - 21
Battery Removal and Installation
Removal (Figure 10)
1. Place unit in the service position (see
SERVICE POSITION on page 20).
2. Disconnect negative (–) cable first, then
positive (+) cable.
3. Remove battery hold-down bracket and
battery from unit.
Installation (Figure 10)
1. Install battery on unit with battery hold-
down bracket.
2. Connect positive (+) cable first, then
negative (–) cable.
3. Coat terminals with dielectric grease or
petroleum jelly.
4. Close hood (see SERVICE POSITION
on page 20).
Cleaning the Battery
(Figure 10)
1. Disconnect negative (–) cable first, then
positive (+) cable.
2. Clean battery cable ends and terminals
with wire brush. Rinse with a weak
baking soda solution.
3. Connect positive (+) cable first, then
negative (–) cable.
4. Coat terminals with dielectric grease or
petroleum jelly.
(
1. Battery
2. Negative (–)
Terminal
3. Negative (–)
Cable
4. Positive (+)
Ter min al
5. Positive (+)
Cable
1
2
4
OF3227
Figure 10
3
5
2
4
1
3
5
Battery for models 992150, 152, 154,
159, 161, 162, 163, 164, 165, 166, 167,
168, 170, 175, 176
Battery for models 992156, 160