Chapter Topics
Book Topics
GrIP User’s Guide
Chapter 5 – GrIP Software
Introduction
These software applications are included with the GrIP Game System,
and are explained in this chapter:
DOS and Windows 95 drivers. These driver programs are required
for GrIP mode. If you are not running Windows 95, only the DOS driver
will be installed on your computer.
GCC – The GrIP Control Center. GCC is a Windows 95 task bar utility
that allows you to check the status of your GrIP MultiPort and enable
or disable keyboard emulation.
GrIPKey. GrIPKey is a Windows 95 application that allows you to
program GrIP controllers to emulate keyboard commands in your
games. You can use GrIPKey “keysets” with any keyboard-controlled
Windows 95 or DOS game.
GKLOAD. GKLOAD is a DOS-based command-line utility that allows
you to load GrIPKey keysets into your GrIP controllers and use them
with DOS games.
GravUtil. GravUtil is a game port and joystick testing utility.
To Next Page
Loading...