Chapter Topics
Book Topics
GrIP User’s Guide
Chapter 5 – GrIP Software
1. Click Apply to apply your new joystick selections (if you have
changed the Current joystick & Joystick Selections).
2. If you are setting up a non-GrIP device, click Calibrate and follow
the instructions on screen to calibrate the joystick. With the
“Gravis GrIP” setting, this option in unavailable, since the GrIP
MultiPort and all GrIP devices self-calibrate.
3. Click on the Test button. Then press each button on the joystick or
pad; watch the corresponding blocks on the Joystick Properties
sheet light up as you press each button. Click OK when finished.
Note: If you experience any problems with the calibration or
button test, click on the GravUtil button to run a more extensive
testing program.
4. When you are finished, click OK to save your changes and close the
properties sheet (or Cancel to close the sheet without saving
changes). Or click on one of the buttons at the bottom of the sheet
(Gravis Special Gameport/Joystick Utilities) to start a related
program:
...Gravis Joystick Applet, cont’d.
To Next Page
Loading...