10
USER MANUAL
GRAVITY Xfusion
EN REV.V01 - 2020
7
INSTALLATION
We recommend, to have your rescue system built into your harness from authorized packers only. To ensure the
rescue parachute has been installed correctly a
compatibility verification
is mandatory! Also, it needs to be recorded
in the service record booklet.
7.1
Original container
The Xfusion system is delivered in its own original container. In case the rescue pocket of your harness does not come
with its own container, the Xfusion system container can be used. There are two different mounting loops to fix the
release handle to the inner container. Please follow the manual of your harness for the proper fitting and installation
of the rescue parachute. The connection between release handle and inner container must never be under tension
after installation, otherwise there’s the risk that the opening of the rescue pocket is impaired or even inhibited.
7.2
Harness integration
In case your harness has an integrated container, please preferably use that. The packed rescue parachute is taken
out of the original container and built into the integrated container of the harness. Please follow the manual handbook
of your harness carfully.
7.3
Integration into an external rescue container
In case your harness does not have an integrated rescue pocket, an external front-container is used. This needs to be
certified and compatible with the rescue parachute. Please follow your container instructions stated in the manual.
Only the application on the GRAVITY airsports & more GmbH front-container was tested from the manufactor side.
8
PACKING INSTRUCTIONS
8.1
Packing requirements
Before each packing the parachute must be inspected by an authorised packer or liscenced dealership. Was the
emergency parachute opened and or used for an emergency case or training then the rescue must be inspected from
the manufacturer or a liscenced dealer or service station.
Before re-packing of the rescue, it is to be checked by a packer. If the parachute has been opened for active operation,
a complete check is to be executed. Before re-packing the Xfusion parachute should be
aired out a minimum of 12
hours, preferably 1 - 2 days.
A suitable packer has to have a diploma of an officially reckognised and certified checking dealership or service station
and also needs to have completed at least one packing course for cross-canopy rescue systems on a certificated
GRAVITY airsports & more GmbH competence center, liscenced dealer or the company itself. We strongly recommend
you get your proper documentation and all your checks from a trusted, recognised service station.
To Next Page
Loading...