4.8
PV PVPU
PU
PSOPU
PVC
PU1 TPVCP
C
B2SKIMMER
MPR TPR TPVCP
PV2 PU1 PSP
assembly instructions
PROTECTIVE PVC STRIPS (POOL INTERIOR
LINING):
Among the pool components there are 2 wide
PVC strips (TPVCP) and 1 narrower PVC strip
(TPVC). The narrower PVC strip is placed by hoo-
king it to the highest nut of the plate closure and
the strip is hung towards the interior of the pool
to cover the screw heads. The 2 wider strips are
hold with adhesive tape so that they cover the
metal brackets that are inside the pool in the
straight area. The function of all these strips is to
protect the pool liner.
Only if your pool comes with: Blanket (MPR)
OR Tapestry (TPR): Warning: it is recommen-
ded to clean all dirt from the pool wall and floor
with the help of a vacuum cleaner before placing
the blanket or tapestry.
Place the protective blanket or mat inside the
pool, eliminating all folds, adjusting and cutting
the excess from the total surface. Carry out the
cut so that the lower profiles and the metal parts
are covered. This way the liner will be protected
when you install it.
20
To Next Page
