4.9
LINER PVC
5º
6º
1º
2º
3º
4º
PV2
20º - 25º
ºC
EN
installation
UNFOLDING THE PVC LINER:
Stretch and extend the liner (L) in the shade so
that it recovers its texture at least 2 hours before
it is to be positioned. Ideal temperature: in order
to handle the liner more easily, ensure that it is
fitted at an ambient temperature of between
20 - 25º C.
The liner is oval in shape, to match the shape
of the pool walls, i.E. Comprised of a rectangle
with a half moon on either side: it can there-
fore only be fitted in one position. Proper liner
placement is essential to prevent folds and wrin-
kles. The PVC liner must be spread out evenly.
Position the liner (L) in the middle of the pool.
Unfold the liner along the main axis of the pool
and extend the side towards the wall plate. The
seam between the bottom and the side must
be butted against the base of the wall plating all
around the pool bottom, to prevent folds. Before
positioning the liner, follow the steps below for
assembly:
1. Start at one of the straight parts. 2. Position
the other half, i.e. the straight part opposite. 3.
Continue from one of the ends on the straight
part up to the middle of a semi-circumference.
4. Complete the other half of this same semi-cir-
cumference. In the event that there is too much,
or insufficient, material (liner), adjust by stretch-
ing or gathering respectively, all the material of
this semi-circumference (distributing it) along
the perimeter of the aforementioned semi-cir-
SERIAL NO.
Examples
FPR301 20233651
FPR451 HY201907
SP385F GP201901
SERIAL NO.:
cumference. 5 and 6. Repeat steps 3 and 4 re-
spectively in order to complete the pool.
NOTE: if there are creases on the base of the
liner or wall, this does not mean that it has to
be changed for another since this does NOT in-
dicate a manufacturing defect.
SERIAL NO.: located on the base or wall of the
liner. Take note of the serial no. in the box on the
instruction sheet for any possible complaints.
21
To Next Page
