4.10
PV
PU
LINER
SF W PU1
PCF
L CH
PCF
4.11
assembly instructions
Hang the liner sides from the pool walls us-
ing the flexible PVC flap (SF). As you hang
the liner in place, secure it provisionally
with clothes-pegs or with the top PVC sec-
tion-pieces (without fitting them fully into
place and with a 5 cm gap between them).
If the liner wall is over large, distribute the
excess evenly all around the pool to pre-
vent wrinkles. If it seems too small, stretch
it evenly around the pool perimeter. *Note:
Some references HAVE NO FLEXIBLE OVER-
LAP (SF) on the liner side. The liner must be
hung by folding it over the wallplate so that
an even 3-4 cm overlap is left.
ATTENTION: In 6-7 m long pools (120 cm
height), the conform overlap has to be 13-14 cm.
FLEXIBLE TOP SECTION PIECES PCF for
Oval Swimming Pools
NOTE: these flexible section pieces are for the
tops of oval swimming pools.
They are fitted on top of the liner once this has
been fitted over the swimming pool sheet and
they do not need to be joined together. They
are positioned one after the other, and when
the perimeter is completed, the extra length is
cut off. Place each PU piece over the top sec-
tion pieces; they must be lined up with those
located in the lower part.
22
To Next Page
