GRECELL T300 - Product Recharging Safety; Equipment Cleaning; Storage Guidelines

A Product Recharging:
e DO NOT charge the unit via power supply systems that operate outside of
AC100-240V.
e DO NOT charge the unit via a solar panel that operates voltage outside of
DC12-26V.
e Always use approved attachment charging cables. we take no responsibility
for any damage caused by using other brand charging cables.
e When charging, please place the product on the ground with no flammable
or combustible materials around. To prevent accidents, never leave the
machine unattended during charging.
e DO NOT charge a product immediately after a long heavy load, because
the product's temperature may be too high. DO NOT charge a product until
it cools down to room temperature.
e Only charge, use the unit within an ambient temperature of 0 to 40°C (32~
104°F). The ideal charging temperature range is 71°F to 82°F(22°C to
28°C).
A Equipment Cleaning
Please make sure that the device is disconnected from all input power and
output devices. Wipe with a clean, dry, non-soft cotton cloth. Removing any
foreign objects, dirt, or other obstructions on the vents on both sides. When
cleaning foreign objects in the side vents, do not allow debris, dirt, or other
Blockage to enter the equipment.
Do not use corrosive cleaners or solvents.
Do not use compressed air to clean the side cooling vents, as it will cause
foreign particles to enter the interior and cause a short circuit.
Note: To avoid the risk of electric shock, do not use metal objects to clean
the ports.
A Storage
Keep the product out of the reach of children. If any children accidentally
swallow parts, please go to a doctor immediately.
If a low-battery warning appears, charge the battery before storing it.
If it will be stored for more than 1 month, please charge it to 50% capacity
and keep it indoors, at normal temperature, and the maximum storage time
shall not exceed 6 months. please keep away from direct sunlight (see the
general specification section).
Store the product in dry environments. DO NOT place the product where it
may contact with water.