How to fix vibration noises at high speeds in Grech Motors Other?
If you experience noises or vibrations at high speeds, it may be due to a damaged or out-of-balance drive line. Contact a qualified drive line shop to properly balance the multiple drive line extensions used in your bus. GRECH MOTORS can recommend one near you.
What to do if exterior sealants are cracking on Grech Motors G40 M2?
If the exterior seams of the bus crack or start lifting, clean the area with rubbing alcohol or mineral spirits. Remove the old silicone with a sharp knife or razor cutter. Clean the area again, then apply a thin bead of exterior silicone and smooth it with your finger for a smooth appearance.
Why is the rear electric step inoperative on my Grech Motors G40 M2?
First, check if the step switch is turned on; it's located inside the cargo area on the right-hand sidewall. If it still doesn't power up, check the fuse in the electrical panel behind the driver's seat. The rear step should be lubricated every 30 days to ensure proper operation.
What to do if the rear A/C blower is inoperative in Grech Motors G40 M2 Other?
Check to make sure all fuses are good. If the rear A/C is still not working, call the Service Department at GRECH MOTORS.
How to troubleshoot an inoperative rear stereo/CD in Grech Motors G40 M2?
Check to make sure all connections are tight. Also remove the stereo and check the fuse located on the backside of the stereo. Also check the fuses in the OEM fuse panel for Radio.
Why are the passenger lights inoperative in my Grech Motors G40 M2?
Check to make sure the switch on the overhead control panel is turned on. There is a 5 minute light timer for the interior lights which will automatically turn them off when the door is open. The ignition switch needs to be turned on for at least 10 seconds to reset the timer.
What causes the back-up alarm to be inoperative on a Grech Motors Other?
Check to make sure reverse lights are coming on, if not, check the fuse located in the FORD fuse panels.
What to do if the side entry door ajar alarm is triggered on Grech Motors G40 M2?
Check to make sure the side door lock is engaged properly.
How do I fix an inoperative paging system in Grech Motors G40 M2 Other?
Check the 5 amp fuse on the circuit board behind the driver. Wiring schematics and instructions for the paging system are located in this manual on page 22.
Daily pre-trip inspection checklist to ensure vehicle safety and operability.
Critical warnings regarding vehicle operation, passenger safety, and emergency procedures.
Procedures for operating electric doors, egress windows, and roof hatches.
Procedures for acquiring parts and managing warranty claims.
Details of the Grech Motors limited warranty for vehicles.
General| Brand | Grech Motors |
|---|---|
| Model | G40 M2 |
| Category | Other |
| Language | English |
To Next Page