6.3.3.5 Buzzer
When the controller is energized or receives remote control signal or the auto key be pressed, the buzzer will give out a beep.
6.3.3.7 Auto key
If one press of this key, the unit will run under AUTO mode and the indoor fan will run at AUTO SPEED.The swing motor
is started when the indoor fan is working. Press this key again to stop the unit.
6.3.3.6 Indicator
There is a dual colour indicator on the running display section, after energized, if the unit is standby, the run indicator will
be red, and if the unit is running, the run indicator will be green.
6.3.3.8 Sleep Function
Set the Temperature T
preset
Setting SLEEP function under HEAT mode, the preset temperature will automatically decrease by 1 after 1hour and
decrease by another 1 after 2 hours. Preset temperature will decrease by 2 in total within 2 hours. After that, the
unit will run at this preset temperature. If the indoor fan will run at preset speed.
℃
℃
T
B
preset
B
TB
preset
B+2℃
T
B
preset
B+1℃
1 hour
2 hours
Over 2 hours
TB
preset
B
TB
preset
B-1℃
T
B
preset
B-2℃
1 hour
2 hours Over 2 hours
Set the Temperature T
preset
Setting SLEEP function under COOL or DEHUMIDIFY mode, the preset temperature will automatically rise by 1 after 1 ℃
hour and rise by another 1 after 2 hours. Preset temperature will rise by 2 in total within 2 hours. After that, the unit will ℃℃
run at this preset temperature.If the indoor fan will run at preset speed.
If set sleep function under fan or auto mode, the set temperature will remain unchanged.
℃
6.3.3.9 Super high fan speed control (GWCN24B5NE1NB )
The indoor fan motor run at super high fan speed : the super high fan speed is defaulted "off " when the unit is turned on by
remote controller.If the controller has memory function, it will memorize the super high set when de-energized and re-energized.
When turned off and then turned on, or switched to cooling mode from other mode, the controller will memorize the super high set,
there is no super high set when switched to Auto, dehumidifying and fan mode.
6.3.3.10 Dry function (GWCN24B5NE1NB )
1). At "on" status under cooling or dehumidifying mode, you can set dry function "on" or "off". If the dry function is set "on", when
the unit is switched off, the indoor fan will run at low speed for 10 mins( during this 10 mins,the swing will maintain its original
operating status, other loads will be turned off), and then the whole unit will be stop. If the dry function is set "off", when the
unit is switched off, the whole unit will be stopped directly.
2).During drying, if the dry function is set "off", the indoor fan will be stopped immediately and the guide louver will be closed.
3).When the dry function is set "on", there is " DRY" displayed on the display windor of remote controller.When turn off the dry
function; there is no " DRY" displayed on the display windor of remote controller.
4
).When de-energized and re-energized, the dry function is at "off" status.
4
).When de-energized and re-energized, the dry function is at "off" status.
5).Unless switched on by the remote controller, the dry function is defaulted "off " .
To Next Page
Loading...
