Service Manual
Installation and Maintenance
56
evaporator
ProcedureStep
condenser
compressor
16. Remove evaporator sub-assy
17. Remove condenser sub-assy
18.Remove compressor
screw
Release the refrigerant at the process
pipe slowly, used the soldering gun to
burn out the connection between suction
pipe and evaporator, capillary and
evaporator and then pull it upward along
the arrow, then the evaporator sub-assy
can be removed.
Use the soldering gun to break the
connection between suction pipe and
compressor, capillary and condenser.
Twist off the 2 screws used for xing the
condenser and chassis with screwdriver,
pull it upward along the arrow direction
and then remove the condenser sub-assy.
Twist off the nuts on compressor with
wrench, pull the compressor upward and
then remove the compressor.
To Next Page
Loading...
