Super Free Match
Service Manual
CONTROL
46
3) FAN
Press this button, Auto, Low, Medium-low, Medium, Medium-high, High speed can be circularly selected.
After powered on, Auto fan speed is default. Under DRY mode, Low fan speed only can be set up.
Low fan Low-Medium fan Medium fan
Medium-High fan High fan
Note: It’s Low fan speed under Dry mode.
4) TEMP
Press this button, the following temperature can be set circularly: the setting temperature, indoor ambient
temperature and outdoor ambient temperature. When the indoor unit firstly power on, it will display the setting
temperature
. If the displaying status is changed to
, displaying the indoor ambient temperature.
is the
outdoor ambient temperature. 5s(3s) later it will return to the setting temperature or it depends on the other
received signal within 5s(3s).
Note: Outdoor ambient temperature display range is 0~60℃ (32~99℉). As for the outdoor ambient
temperature below 0 it displays 0℃(32℉).
“
” function is applicable to partial of models.
Warm tips: When operating buttons on the cover, please make sure the cover is closed completely.
5) CLOCK :
Press this button, the clock can be set up, signal
blink and display. Within 5 seconds, the value can be
adjusted by pressing ＋ or－ button, if continuously press this button for 2 seconds above, in every 0.5seconds,
the value on ten place of Minute will be increased 1. During blinking, repress the Clock button or Confirm button,
signal
will be constantly displayed and it denotes the setting succeeded. After powered on, 12:00 is
defaulted to display and signal
will be displayed. If there is signal
be displayed that denotes the current
time value is Clock value, otherwise is Timer value.
6) LIGHT:
Press LIGHT button at unit On or Off status, Light On and Light Off can be set up. After powered on, Light
On is defaulted.
7) TURBO:
Under Cool or Heat mode, press this button can turn on or turn off the Turbo function. After the Turbo
function turned on, the signal of Turbo will display. The signal will be automatically cancelled if changing the
To Next Page
Loading...
