Gree GJC08BU-A6NRNJ2A - Page 17

17
4. OPERATION GUIDE
TIMER PREVIEW : If a timer has been set, you can view the time remaining by pressing the Timer
(
on the remote) button once. If any adjustments are made and conrmed at that point, the timer
will be recalculated.
DISPLAY PRECISION : When there are less than 10 hours remaining on the timer, the displayed
time is rounded up to half an hour. When there are more than 10 hours remaining, the displayed time
is rounded up to the hour. For example, if the remaining time is 4 hours and 15 minutes, the 2-digit
display will show “ 4.5 ”.
TIMER-OFF SETTING
▪ To set a timer to switch off the unit, press the Timer (
on the remote) button while the unit is running.
On the remote control, the indicator TIMER OFF will be ashing on the LED screen.
▪ Use the
or buttons to select the desired time value. The timer can be set between 0.5 and 24
hours and is adjusted by increments of 0.5 hour for the rst 10 hours and 1 hour for greater time values.
Holding down the button for more than 2 seconds will allow faster time changes.
▪ After setting the desired time, the system will automatically activate the timer after 5 seconds (on the
remote, press the Timer (
on the remote) button to conrm the set time).
▪ If the time value is left at “ – – ” on the control panel screen, the system will automatically exit the timer
setting mode after 5 seconds of inactivity.
▪ To cancel a set timer-off, press the Timer (
on the remote) button twice within 5 seconds.
TIMER-ON SETTING
▪ To set a timer to switch on the unit, press the Timer (
on the remote) button while the unit is turned
off. On the remote control, the indicator TIMER ON will be ashing on the LED screen.
▪ Use the
or buttons to select the desired time value. The timer can be set between 0.5 and 24
hours and is adjusted by increments of 0.5 hour for the rst 10 hours and 1 hour for greater time values.
Holding down the button for more than 2 seconds will allow faster time changes.
▪ After setting the desired time, the system will automatically activate the timer after 5 seconds (on the
remote, press the Timer (
on the remote) button to conrm the set time).
▪ If the time value is left at “ – – ” on the control panel screen, the system will automatically exit the timer
setting mode after 5 seconds of inactivity.
▪ To cancel a set timer-on, press the Timer (
on the remote) button twice within 5 seconds.