Gree GKH42K3FI - Page 143

U-Match Series DC Inverter Service Manual
140
Disassembly of air deflecting plate modules
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during
disassembly, especially the joints of the air deflecting plate.
Step
Illustration
Handling Instruction
Disassembly of
sub-assy of air
deflecting plate
●Remove the air deflecting
plates from the air
deflecting plate support
assembly, and then
remove both ends from the
air sweeping motor. Joint
(As is shown in the graph,
arrow represents the
support assembly and
circle the air sweeping
motor joint.)
Disassemble of water-containing plate modules
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during
disassembly.
Step
Illustration
Handling Instruction
Disassemble of
water-containing plate
modules
●Remove the
water-containing plate
modules.
Disassembly of evaporator components
Remark: Make sure that the power supply is cut off and protect the copper tube and aluminum fin. If the
time for disassembly shall be long, seal the copper tube.
Step
Illustration
Handling Instruction
Disassembly of
evaporator
components
●Unscrew the 6 screws of
evaporator, 3 screws of
water groove press board
and the 2 screws of water
board to remove the
evaporator.
Disassembly of fixing plate sub-assy for air sweeping fans
Remark: Make sure that the power supply is cut off before disassembling and protect all the parts during
disassembly.
Step
Illustration
Handling Instruction
Disassembly of fixing
plate sub-assy for air
sweeping fans
●Remove the display
board, mounting support
and mounting plate of
swing motor in turn.