Gree GMV-60WL/A-T(U) - Page 118

DC Inverter Side Discharge VRF Ⅱ for North America
116
Removal operation for 4-way valve
Remark: Before removing the 4-way valve, please make sure that there’s no refrigerant inside the pipeline of system
and then power is disconnected.
Process
Photo
Operation Instruction
1.Disconnect
the coil of
4-way valve
from the 4-way
valve
Remove the coil of
4-way valve at first
2.Disconnect
the 4-way valve
and connection
pipeline
Weld those 4
connection spots on
4-way valve, and
then pull out the
connection pipe
Note: During welding
process, do not let
the flae burn out
other parts
3. Replace
4-way valve
Replace 4-way
valve
Note: During welding
process, do not let
the flame burn out
other parts