Gree GMV-N140U/A-T - Page 87

GREE GMV5 INDOOR UNIT SERVICE MANUAL
82
Query Code
Query Content
Query Sub-item
Level 2 Query Content
C05
Historical fault query ingress of the current
IDU
01
Fault 1
02
Fault 2
03
Fault 3
04
Fault 4
05
Fault 5
C06
Preferential operation query
C07
Temperature query for environment temperature sensor of the current IDU
C08
Prompt time query for air filter cleaning
C10
Static pressure setting query of ODU
01
Module 1
02
Module 2
03
Module 3
04
Module 4
C11
Indoor unit quantity query in one-to-many control mode
C12
Temperature query for outdoor environment temperature sensor
C13
CAN2 bus line ID query
C14
Inlet-tube temperature query of IDU
C15
Outlet temperature query of IDU
C16
Opening degrees query of electronic expansion valve of IDU
n2
Capacity configuration ratio upper-limit query of outdoor and IDUs
n4
Highest capacity output limitation query
n6
Historical fault query ingress of ODU
01
Fault 1
02
Fault 2
03
Fault 3
04
Fault 4
05
Fault 5
A6
Unit cooling/heating function
A7
Outdoor silent mode
5.4.3 Parameter Settings
For parameter settings, users can set user parameters and engineering parameters of the unit. The
parameter setting method is as follows:
(1) After entering parameter query, switch the query code to “C00”. Press and hold “
CLOCK
“ for
five seconds to enter the parameter setting status. The setting text is displayed and “P00” blinks
in the temperature area.
(2) Press “ ” to switch the setting code and select a unit parameter to be set (see Table 2.6
for parameters that can be set).
(3) Press “
TEMP
” to enter parameter settings. The current parameter value blinks in the timer area.