INSTALLATION IN A DOUBLE-HUNG SASH WINDOW
14
Note: If the inner width of window is below 20.5" 520mm, please remove the
adjusting panel from window frame and then cut the window frame to make its
width the
same as the width of window.
Adjusting panel
Window frame
Rear connector (upper)
Clap
Rear connector (lower)
Window frame
Joint B+C
Inner side
ScrewsScrews
Protective grille
Cut
1. Install rear clip: Aim the rear clip (upper) at the rear clip (lower), fix them
together, firmly press the clasp into the groove.
2. Clamp joint B+C into the inner side of window frame along the direction of
arrow.
3. Fix the protective grille on joint B+C with 2 screws.
4. Fix the
support on the outer side of window frame with 2 nuts, spring washer,
washer and bolt.
00738_ 10-11-2015Owner's Manual Air conditioner Portable (Shiny) Final_Climatiseur Mobile8.5x11 An+FR 15-12-18 16:23 Page17
To Next Page
Loading...
