Gree GPC09AK-K5NNA3A

38
Maintenance
Service Manual
● Drainage way as follows.
1. In Cool, Dry or Heat mode operating, the condensation water will be drained to the chassis.(As show in Fig.6)
2. 2. When the chassis is full with water, the buzzer will give out 8 sounds and "H8" is displayed to remind user to discharge water,the unit
will turned off about 2min latter, and all buttons are invalid.
To empty the chassis, please follow the instructions bellow.
● Turn the unit off and unplug from the electrical outlet.
● Use a small pan or move the unit to a suitable place to drain the water.
● Take the drainage pipe from the clip and pull out the rubber plug on the drainage pipe to drain the water.
● Drain the water into the small pan or a suitable place.
● Once draining is complete,re-install drain cap.
● Press ON/OFF button to restart the unit.
2.Use the continuous drainage option from the middle hole
NOTICE:Water can be automatically emptied into a oor drain by attaching 14mm inner diameter hose (not included).
(1) Remove the continuous drain cap 1 by turning it counter clockwise then remove the rubber stopper 2 from the spout. (As show
in Fig.7)
(2) Screw the drain connector to(included in the package) the spout by turning clockwise.(As show in Fig.8)
(3) Insert the drainage hose into drain connector.(As show in Fig.9)
ATTENTION:
When using continuous drainage option from the middle hole, place portable on a level surface and make sure garden hose is clear
of any obstructions and is directed downward. Placing portable on an uneven surface or improper hose installation may result in
water lling up the chassis and causing the unit to shut off. Empty water in the chassis if shut off occurs, then check portable location
and hose for proper setup.
Fig.7
Fig.6
Fig.9
Fig.8

adjusting panel
window panel
cut