40
Maintenance
Service Manual
8. Cut the sponge B to a proper length and attach it to the
window panel.
9. Close the window sash securely against the Window panel.
10. Cut the sponge A to a proper length and seal the gap
between upper part of inner window sash and outer window
sash.
11. Fix the inner window with window bracket and screw, so
that it can not slide vertically.
2. Clamp joint B+C into the inner side of window panel along
the direction of arrow.
3. Fix the protective grille on joint B+C with screws.
4. Fix the support on the outer side of window panel with nuts, spring
washer,washer and bolt.
5. Fix the rain shield on the support with nuts, spring washer, washer
and bolt.
(Note: protective grille, support, rain shield, nut, bolt, spring washer
and washer are optional accessories; some models are without these
accessories.
6. Cut the sponge B to a proper length and attach it to the window
stool.
7. Install the window panel into the window stool.
7.1 If the heigth of the window is less than 20.5"(520mm).
The window panel cannot be installed in windows less than
20.5"(520mm) high.
(1) Remove the adjustment panel from the window panel, and cut the
window panel to the same width as the window.
(2) Open the window sash and place the window panel on the
window stool.
(3) Secure the window panel to the window stool with screws.
7.2 If the inner width of the window is between 20.5" (520mm) and
37.4"(950mm) inclusive.
(1) Open the window sash and place the window panel on the
window stool.
(2) Slide the adjustment panel to t the window stool height.
(3) Secure the window panel to the window stool with screws.
9.4 Installation in a sliding sash window
(adhesive type)
window sash
sponge A
outer window
inner window
plastic window
wooden window
window bracket
clasp
rear connector (lower)
rear connector (upper)
oint B+C
protective grille
washer
Nut
Nut
Screws
Washer
Window
panel
Cut
Window panel assemble
To Next Page
Loading...
