Usage Location
1.Where room area is smaller than 15m ,and wall(or building)has well heat insulation effect.As shown
in following figure,if unit is in shown location,the cooling effect will bebetter.
2.If room area is larger than 20m ,for example workshop or factory,the unit can only offer cooled air to
partial area(as shown in following figure),and people in this area can enjoy better cooling effect.
- 2-
When only used as dehumidifier,remember to take off heat
discharge pipe from unit and install it onto unit when the unit is
used as air conditioner.Since partial indoor air will be heated
as heat air and discharged to outside by discharge pipe after
cyc-ling then outdoor air will enter to maintain balance air
pressure,thus the air conditioner will only lower temperature
of partial re-gional air of indoor room instead of turning entire
indoor air to a lower temperature.
2
2
WORKING PRINCIPLE
window or wall
discharge pipe
cooled air
Heated air
Cooling
Flow direction
of cooled air
Mobile AC
Heat air
Room
region
1.5~2m
60~70
(Sector cooling area)
To Next Page
Loading...
Need help?
General
