51
Maintenance
Service Manual
Optional 5: Disassemble for installation
in sash window
Optional 5-2: Disassembly for
installation in the wall
Optional 5-1: Disassembly for
installation in window
1. Remove joint A:
Press the clasp and lift joint A upwards to remove it.
1.Remove joint A:
Press the clasp and lift joint A upwards to remove it.
2. Remove joint D:
remove joint D from joint E.
3. When heat discharge pipe is removed, Install the plastic
cover into joint D in case of the insect into the house.
2. Remove the window adapter. Pull out and remove the
window adapter by pushing down two “PUSH” markings,
and slide and close the exhaust cover in the window
panel. (Optional)
1. Remove joint A:
Press the clasp and lift joint A upwards to
remove it.
2. Remove joint D:
remove joint D from joint E.
"PUSH"
"PUSH"
Upwards
Joint A
Joint D
Joint E
clockwise
Upwards
Disassemble
Joint A
Upwards
Clasp
Disassemble
Joint A
Upwards
Clasp
Disassemble
Joint A
Upwards
Clasp
Disassemble
Joint A
To Next Page
Loading...
