69
Maintenance
Service Manual
Remove 4 screws used for xing the support
strip and then take out the support board 3.
Remove 3 screws used for xing the air duct
sub-assy 2 and then take out the air duct
sub-assy 2.
Remove 2 screws used for xing the propeller
housing cover and then take it out.
Screws
Screws
out the air duct
sub-assy 2
Screws
Propeller housing cover
Step
9.
8.
7.
Procedure
Remove support board 3
Remove out the air duct sub-assy 2
Remove propeller housing cover
Supporting Board 3
To Next Page
Loading...
